AAK unique 5 steps sand cleaning method replaces the traditional method commonly used by peers, and completely solves the problem of valve stuck or filter blockage of hydraulic relief valves caused by hidden danger in sand cleaning. The American customer placed an order for the hydraulic relief valves to AAK 3 days after the test run.
Most of the bodies of the hydraulic relief valves are made of nodular iron, vermicular iron and gray iron and cast by sand turning with resin sand as the modeling medium. Therefore, there is sticky sand in the casting, which is easy to cause valve jamming and filter blockage. Most of the common sand cleaning methods of hydraulic relief valves in the same industry are shot blasting and electrochemical sand cleaning. These methods have limitations and are not conducive to the stability of hydraulic relief valves.
Gabriel is a purchaser of a hydraulic company in the United States. In previous years, he purchased the hydraulic relief valves in the United States. Recently, there is an order for hydraulic relief valves. The production of the original domestic manufacturer is full schedule, while the other hydraulic relief valve manufacturers dislike the small quantity and are unwilling to accept the order. The company asked him to check with Chinese hydraulic relief valve manufacturers. Among several hydraulic relief valve manufacturers recommended by his colleagues, Gabriel chose 3 of them to send samples after a round of comparison. After 20 days, the samples of these 3 hydraulic relief valve manufacturers were generally stable and prone to valve jamming or filter blockage. The root cause was the incomplete sand cleaning process of the hydraulic relief valves.
When browsing B2B websites, Gabriel saw that AAK website www.aakindustry.com introduced the 5 steps sand cleaning method of hydraulic relief valves. He left a message on our website: Can AAK make the hydraulic relief valves not stuck or the filter not blocked? We replied him directly: AAK hydraulic relief valves with 5 steps sand cleaning method have been recognized by German customers. You are welcome to try the order. Gabriel subconsciously approved AAK hydraulic relief valves but was still some concerned because of no cooperation before, so he asked for samples to test first. According to the draft of hydraulic relief valves sent by him, we sent samples in 2 weeks. Gabriel issued official PO on the 3rd day after receiving the hydraulic relief valve samples for commissioning, and requested that the bulk goods to be 100% sand cleaned thoroughly.
AAK adopts more efficient sand cleaning method and has its own unique 5 steps sand cleaning method for small and complex castings, namely: Artificial aging - Pickling - Rinsing - Rust prevention - Ultrasonic cleaning. Artificial aging is used to reduce the binding force between the casting and sand, acid pickling is used to remove the oxide skin at the joint between the sand and the casting, so as to peel the sand off the casting, and then the explosion of compressed air during ultrasonic cleaning is used to make the sand fall off, so as to achieve the purpose of 100% sand cleaning. Gabriel issued the PO in 3 days after receiving AAK hydraulic relief valves for testing. This is a witness of AAK unique sand cleaning methods.
AAK hydraulic relief valves do not block the valve or filter, which is due to AAK unique 5 steps sand cleaning method. You can also have a small try.
AAK HYDRAULIC VALVES (200) 2022-04-18